Component Inspection
1.

Ignition Switch "OFF"

2.

Disconnect battery (-) cable.

3.

Refer to "Shop Manual" and disconnect the APS connector.

4.

Measure resistance between Pin No. 2(APS 2 power) and Pin No. 6(APS 2 ground) of the APS connector.

Specification : Approx. 1.4 ~ 2.6kΩ

5.

Is the measured value within specification?

▶ Fault is intermittent caused by poor contact in the sensor’s and/or ECM’s connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure.

▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.

warning

When install a part, tighten it within specification.

When drop down the part, check part's operating condition whether it is damaged or not.

Яндекс.Метрика