5.
Measure voltage of Pin No. 2(motor -) of the VSA connector and chassis ground.
Specification : B+
Ignition Switch "OFF"
Refer to "Shop Manual" and disconnect the VSA connector.
Ignition Switch "ON"
Measure voltage of Pin No. 1(motor +) of the VSA connector and chassis ground.
Measure voltage of Pin No. 2(motor -) of the VSA connector and chassis ground.
Specification : B+
Ignition Switch "OFF"
Disconnect battery (-) cable.
Refer to "Shop Manual" and disconnect the VSA connector.
Measure resistance between Pin No. 1(motor +) of the VSA and chassis ground.
Measure resistance between Pin No. 2(motor -) of the VSA and chassis ground.
Specification : ∞ Ω
Is the measured value withing specification?
 | ▶ Go to "Power Circuit Inspection" procedure. |
 | ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
Ignition Switch "OFF"
Refer to "Shop Manual" and disconnect the VSA connector.
Ignition Switch "ON"
Measure voltage of Pin No. 3(position sensor power) of the VSA connector and chassis ground.
Specification : Approx. 5V
Is the measured value withing specification?
| ▶ Go to "Ground Circuit Inspection" procedure. |
| ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
Ignition Switch "OFF"
Disconnect battery (-) cable.
Refer to "Shop Manual" and disconnect the VSA connector.
Measure resistance between Pin No. 5(position sensor ground) of the VSA and chassis ground.
Specification : ∞ Ω
Ignition switch "OFF"
Refer to "Shop Manual" and disconnect the VSA connector.
Ignition switch "ON"
Measure voltage of Pin No. 3(position sensor power) of the VSA connector and chassis ground.(A)
Measure voltage between No. 3(position sensor power) and Pin No. 5(ground) of the VSA connector.(B)
Specification : Difference (A) and (B) is less then 200 mV
Is the measured value withing specification?
| ▶ Go to "Signal Circuit Inspection" procedure. |
| ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
Ignition Switch "OFF"
Refer to "Shop Manual" and disconnect the VSA connector.
Ignition Switch "ON"
Measure voltage of Pin No. 4(position sensor signal) of the VSA connector and chassis ground.
Specification : Approx. 4.1V
Is the measured value withing specification?
| ▶ Go to "Component Inspection" procedure. |
| ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
