3.
Perform "Actuation Test" for Injector.
Fig.1) Injector Disable - Cylinder 1 Actuation Test
Connect GDS to Data Link Connector(DLC).
IG KEY "ON" & ENG "OFF".
Perform "Actuation Test" for Injector.
Fig.1) Injector Disable - Cylinder 1 Actuation Test
IG KEY "OFF".
Connect VMI to GDS and select "Oscilloscope".
Connect Channel A positive probe to Pin No.2(High side) and Channel A negative probe to Pin No.1(Low side).
Connnect CH AUX probe to control wire of Injector.
Warm up the engine to normal operating temperature.
Specification : Refer to Signal Waveform & Data
Fig.2) Engine Idle after Warm Up
Fuel injection time - Approx. 1545us
CH. A - Injector Max 64.4V
CH. AUX - Injector Current MAX 9.09A
Fig.3) Approx. 2500rpm
Fuel injection time - Approx. 900us
CH. A - Injector Max 64.4V
CH. AUX - Injector Current MAX 9.09A
Fig.4) At Acceleration
Fuel injection time - Approx. 3360us
CH. A - Injector Max 65.2V
H. AUX - Injector Current MAX 9.09A
IG Key "OFF".
Disconnect Injector connector.
Measure resistance between Pin No.2(High side) terminal and Pin No.1(Low side) terminal of the Injector. (Component Side)
Specification : Approx. 1.40 Ω [25°C(77°F)]
Fig.5) Resistance of Injector
Does the Injector operate properly? (Check variation)
 | ▶ Carefully re-do this troubleshooting guide steps. |
 | ▶ If problem still occurs, replace Injector and perform "Resetting Adaptive Values" of Vehicle S/W Management. ▶ Go to "Verification of Vehicle Repair" procedure. |
※ In case injectors are replaced, perform following procedure;
Connect GDS to DLC(Data Link Cable).
IG "ON" & ENG "OFF"
Select the "Vehicle S/W Management" about related DTC with GDS.
Fig.1) Press "Reset" button to progress for next procedure
Fig.2) Press "OK" button(IG ON, ENG OFF)
Fig.3) Completed
