Connect GDS to Data Link Connector(DLC).
Ignition "ON"
Monitor "Diagnostic Trouble Codes(DTC)" with GDS.
Is DTC status displayed as Present?
Fig.1) Diagnostic Trouble Code(DTC) is shown above
![]() | ▶ Go to "Monitor GDS Data" procedure. |
![]() | ▶ Go to "Verification of Vehicle Repair" procedure. |
Connect GDS to DLC(Data Link Cable).
Check the "Current Data" about related DTC with GDS during Cranking the engine.
Fig.1) Synchronization of CKPS & CMPS
If the parameter is not similar with shown data, measure related waveforms with GDS.
Fig.2) Normal Waveforms of CKPS, CMPS-IN at Engine idle.
A : CKPS & CMPS(Intake side) syncronization - There are about 4~5 teeth between the CKPS missing tooth and CMPS signal.
Are the parameters displayed correctly?
![]() | ▶ Fault is intermittent caused by poor contact in the sensor’s and/or PCM’s connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure. |
![]() | ▶ Go to "System Inspection" procedure. |