Component Inspection
■ Perform ETC Motor Actuation Test
1.

Connect GDS to Data Link Connector(DLC).

2.

G KEY "ON" & ENG "OFF".

3.

Perform "Actuation Test" for ETC Motor.

■ Inspect ETC Motor
4.

IG Key "OFF".

5.

Disconnect ETC Motor connector.

6.

Measure resistance between power and control terminal of the ETC Motor. (Component Side)

Specification : Approx. 2 ~ 3Ω [20°C(68 °F)]

■ Confirm Part Inspection
7.

Does the ETC Motor operate properly? (Check variation)

▶ Go to "Verification of Vehicle Repair" procedure.

▶ Carefully re-do this troubleshooting guide steps.

▶ If problem still occurs, replace ETC Motor and then go to "Verification of Vechicle Repair" procedure.

Яндекс.Метрика