13576064

1.

Remove the drive belt.

(Refer to Timing System - "Drive Belt")

2.

Remove the engine room under cover.

3.

Remove the passenger side front tire.

4.

Remove the crankshaft damper pulley (A).

Tightening torque :

147.1 ~ 156.9 N.m (15.0 ~ 16.0 kgf.m, 108.5 ~ 115.7 lb-ft)

note

There are two methods to hold the ring gear when removing or installing the crankshaft damper pulley.

●

Install the SST (09231-3N100 / 09231-2B100) to hold the ring gear after removing the starter.

●

Install the SST (09231-2W100 / 09231-3D100) to hold the ring gear after removing the dust cover.

1.

Remove the air guide bracket (A).

Tightening torque :

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

2.

Remove the dust cover (A) and unfasten the transaxle mounting bolt (B).

3.

Adjust the length of the holder nuts (A) so that the front plate of the holder (B) puts in the ring gear (C) teeth.

4.

Adjust the angle of the links (D), and fasten the bolt 70mm(2.7559in) in the original mounted hole.

5.

Tighten the bolts and nuts of the holder and links securely.

5.

When installing the pulley, the groove on the pulley should be positioned outside.