4.
Remove the purge control solenoid valve (C).
Turn the ignition switch OFF.
Disconnect the PCSV connector.
Measure resistance between the PCSV terminals 1 and 2.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Disconnect the purge control solenoid valve connector (A).
Disconnect the vapor hoses (B) from the purge control solenoid valve.
Remove the purge control solenoid valve (C).
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
Use care to keep foreign material out of the valve.
Install in the reverse order of removal.
