3.
Remove the mounting nuts (B).
Turn ignition switch OFF.
Disconnect the accelerator position sensor connector.
Measure resistance between voltage supply terminal and ground terminal of APS1.
Measure resistance between voltage supply terminal and ground terminal of APS2.
Check that the resistance is within the specification.
Specification: Refer to Specification section.
Turn ignition switch OFF and disconnect the battery negative (-) terminal.
Disconnect the accelerator position sensor connector (A).
Remove the mounting nuts (B).
Remove the cap (A).
Remove the mounting bolt (A), and then remove the accelerator pedal module.
Install in the reverse order of removal.
Accelerator pedal mounting nut:
12.8 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
Accelerator pedal module mounting bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
