2.
Remove the air duct (A).
Turn the ignition switch OFF and disconnect the battery (-) terminal.
Remove the air duct (A).
Disconnect the boost pressure sensor connector (A).
Removal the boost pressure sensor (B) after removing the mounting bolts.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Install in the reverse order of removal.
Boost pressure sensor mounting bolt:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
