3.
Disconnect the ECM connector (A).
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Remove the air cleaner.
(Engine Mechanical System - "Air Cleaner")
Disconnect the ECM connector (A).
Disconnect the fuel inlet tube quick-connector (A) and fuel outlet tube quick-connector (B).
Disconnect the water sensor connector (A) and fuel heater connector (B).
Remove the fuel filter assembly after loosening the bracket mounting nuts (C).
Remove the fuel filter assembly (A).
Be careful not fuel flow in ECM pin.
Remove the water sensor (A).
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Install in the reverse order of removal.
