3.
Disconnect the brake fluid level switch connector (A), and remove the reservoir cap.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the ECM.
(Refer to Engine Control / Fuel System - “Engine Control Module (ECM)”)
Disconnect the brake fluid level switch connector (A), and remove the reservoir cap.
Remove the brake fluid from the master cylinder reservoir with a syringe.
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
Disconnect the brake tube (A) from the master cylinder by loosening the tube flare nut.
Tightening torque :
18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)
Remove the clutch hose. [MT only]
Remove the master cylinder (A) from the brake booster after loosening the mounting nuts (A).
Tightening torque :
9.8 ~ 15.7 N.m (1.0 ~ 1.6 kgf.m, 7.2 ~ 11.6 lb-ft)
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the ECM.
(Refer to Engine Control / Fuel System - “Engine Control Module (ECM)”)
Disconnect the brake fluid level switch connector (A), and remove the reservoir cap.
Remove the brake fluid from the master cylinder reservoir with a syringe.
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
After loosening the mounting screws (A), then remove master cylinder reservoir.
Tightening torque :
1.0 ~ 1.5 N.m (0.10 ~ 0.15 kgf.m, 0.74 ~ 1.11 lb-ft)
Install in the reverse order of removal.
After installing, bleed the brake system.
(Refer to Brake system bleeding)
After be equipped perform bleeding air procedure in clutch release cylinder after pouring the brake fluid.
(Refer to Clutch - "Clutch Release Cylinder") - [MT only]
Install in the reverse order of removal.
After installing, bleed the brake system.
(Refer to Brake system bleeding)
After be equipped perform bleeding air procedure in clutch release cylinder after pouring the brake fluid.
(Refer to Clutch - "Clutch Release Cylinder") - [MT only]
