3.
Disconnect the stop lamp switch connector (A).
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
Disconnect the stop lamp switch connector (A).
Remove the stop lamp switch.
(Refer to Brake System - "Stop lamp switch")
Remove the brake pedal member mounting bolt (A).
Remove the snap pin (A) and clevis pin (B).
Remove the brake pedal member assembly mounting nuts and then remove the brake pedal assembly.
Check the bushing for wear.
Check the brake pedal for bending or twisting.
Check the brake pedal return spring for damage.
Pre-tighten the bracket fixing bolt (A) in dash panel.
Install the brake booster and brake pedal member fixing nuts (A) securely.
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
Tighten the bolt (A) securely in dash panel.
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
Install the snap pin (A) and clevis pin (B).
Before installing the pin, apply the grease to the clevis pin.
Use a new snap pin whenever installing.
Install the stop lamp switch securely.
Connect the stop lamp switch connector (A).
Adjust the brake pedal height and free play.
Check the brake pedal operation after installing the brake pedal.
Install the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
Reconnect the battery negative cable.
