2.
Remove the rear console cover (A).
The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure.
Release the parking brake lever and parking brake cable is loose.
Remove the rear console cover (A).
Loosen the adjusting nut (A) and the parking brake cables (B).
Parking brake lever in the car must be in fully loosened position.
Raise the vehicle, and make sure it is securely supported.
Remove the rear tire and wheel.
Remove the parking brake cable (A), after removing the clip (B).
Loosen the parking brake cable bracket bolts and remove the parking brake cable (A).
Install the parking brake cable (A).
Tightening torque :
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)
Install the parking brake cable (A), and then install the clip (B).
Install the parking brake cable (B).
Install the parking brake cable adjuster, then adjust the parking brake lever stroke by turning adjusting nut (A).
Parking brake lever stroke:
5 ~ 7 clicks (Pull the lever with 196N (20 kgf, 44 lbf))
Release the parking brake lever fully, and check that parking brakes do not drag when the rear wheels are turned. Readjust if necessary.
Make sure that the parking brakes are fully applied when the parking brake lever is pulled up fully.
Install the rear console cover (A).
Install the rear tire and wheel.
Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Remove the rear console cover (A).
Apply the brake pedal 20 times with the force of 10kgf after bleeding. Then for the cable to settle in, apply the parking brake full stroke more than 3 times.
Install the parking brake cable adjuster, then adjust the parking brake lever stroke by turning adjusting nut (A).
Parking brake lever stroke :
5 ~ 7 clicks (Pull the lever with 196N (20 kgf, 44 lbf))
Release the parking brake lever fully, and check that parking brakes do not drag when the rear wheels are turned. Readjust if necessary.
Make sure that the parking brakes are fully applied when the parking brake lever is pulled up fully.
Install the rear console cover.
Re-setting of the parking brake is necessary after overhauling the caliper body, or if the brake calipers, housing, parking brake cable or brake discs have been changed.
Remove the rear console cover (A).
Loosen the parking brake cable until both operating levers rest in fully off position.
Bring the brake pads in their operating position by pressing the brake pedal down several times until there is resistance.
Tension the parking brake cable by tightening the adjusting nut, until the operating levers on both calipers lift from the stop, up to a distance of (A) and (D) between operating lever (B) and stopper (C).
Distance (A+D): Max. 3 mm (0.12 in)
Parking brake lever in the car must be in fully loosened position.
If the handbrake cables where changed, actuate the parking brake a few times with maximum force to stretch the parking brake cables, and then control adjusting as above.
Check the wheels of their free operation.
Install the rear console cover.
