2.
Rotating counter-clockwise shift lever knob (A).
Check the select cable for proper operation and for damage.
Check the shift cable for proper operation and for damage.
If there is sticky feel. Readjust control cable length.
Check the boots for wear abrasion sticking, restricted movement or damage.
Shift lever to "4rd" gear position.
Rotating counter-clockwise shift lever knob (A).
Remove the floor console assembly.
(Refer to Body - " Floor Console")
Remove the rear heating joint duct (A).
Remove the bracket (A).
Remove the select cable (B) after removing the snap pin (A).
Remove the cable socket (C) from lever assembly after pulling in the direction of the arrow.
Remove the shift cable (B) after removing the clip (A).
Remove the cable socket (A) from lever assembly after pulling in the direction of the arrow.
Remove the crash pad.
(Refer to Body - "Crash pad")
Remove the Heater Unit.
(Refer to Heating,Ventilation And Air conditioning - "Heater")
Remove the retainer (A) after loosen the nut (B).
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
Remove the shift & select cable.
Remove the pin (A) and washer (B).
Make unlock clip (C) and then remove the shift & select cable and the clip (C) from the bracket.
When installing, set room side shift lever and T/M side lever to "4rd" gear position.
Tighten the nut (B) after install the retainer (A).
Tightening torque:
11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)
Install the crash pad.
(Refer to Body - "Crash pad")
Install the Heater Unit.
(Refer to Heating,Ventilation And Air conditioning - "Heater")
Check the Shift lever is in "4rd" gear position.
Install the cable socket (A) on the shift lever assembly.
Install the shift cable (B) after installing the clip (A).
Install the select cable socket (C) on the shift lever assembly.
Install the clip (A) after installing the select cable (B).
Install the bracket (A).
Install the rear heating joint duct (A).
Install the floor console assembly.
(Refer to Body - "Floor Console")
Rotating clockwise shift lever knob (A).
Install the control cable (B) and clip (A) on the bracket.
Do not reuse the clip (A).
Install the control cable
Install the control cable (A) in transaxle lever pin.
Ensure to press adjust locking button in direction of "C".
Install the washer (A) and pin (B).
Install the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
Install the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
Ensure to press adjust locking button in direction of "C".
If there is sticky feel. Readjust control cable length.
Install the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
Install the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
