Turn ignition switch OFF.

Disconnect the solenoid valve connector (A).

Measure resistance between sensor signal terminal and sensor ground terminal.

Check that the resistance is within the specification.

Change the shift lever to "N" range.

Remove the valve body assembly.

(Refer to Hydraulic System - "Valve Body")

Disconnect the input & output speed sensor connector (A).

Loosen the main connctor bolt (B).

Dissconnect the solenoid valve connector (A).

Remove the solenoid valve connector clip (B) after loosening a bolt and then remove the connector by pushing down to it.

Install in the reverse order of removal.

note

●

Replace the gasket (A) before reinstalling the valve body cover.

●

Refill the automatic transaxle with fluid.

(Refer to Hydraulic System - "Fluid")