2.
Rotate the Ignition lock switch lever to the direction of the arrow to check the continuity.
Clutch pedal position | Ignition lock switch |
Released | Open |
Fully pressed | Continuity |
Check ignition lock switch pull-up voltage
IG KEY "OFF", ENGINE "OFF".
Disconnect ignition lock switch connector.
IG KEY "ON".
Measure the voltage between signal terminal of ignition lock switch harness connector and chassis ground.
Specification : 11.5V ~ 13.0V
Check open in ignition lock switch signal circuit
IG KEY "OFF", ENGINE "OFF".
Disconnect ignition lock switch connector and ECM connector.
Check continuity between signal terminal of ignition lock switch signal harness connector and ECM harness connector.
Specification : Continuity ( below 1.0Ω )
IG KEY "OFF", ENGINE "OFF".
Disconnect ignition lock switch connector.
Check continuity between ignition lock switch signal harness connector terminal 4 and chassis ground.
Specification : Continuity ( below 1.0Ω )
Remove the clutch & ignition lock switch.
Rotate the Ignition lock switch lever to the direction of the arrow to check the continuity.
Clutch pedal position | Ignition lock switch |
Released | Open |
Fully pressed | Continuity |
