3.
Install the emergency fastening device with bolt (B).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Remove the ignition key from the vehicle.
Disconnect the battery negative cable and wait for at least thirty seconds.
Install the emergency fastening device with bolt (B).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Connect the emergency fastening device connector (A).
Install the center pillar lower trim.
(Refer to Body - "Center pillar trim")
Insert the seat belt to the emergency fastening device (A).
Make sure the lock pin is connected in properly.
Reconnect the battery negative cable.
After installing the emergency fastening device, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
