3.
Check that the motor operates normally. Replace the motor if it operates abnormally.
No. | Description |
1 | Battery (+) |
2 | Parking |
3 | Ground |
4 | Signal |
Remove the connector from the rear wiper motor.
Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively.
Check that the motor operates normally. Replace the motor if it operates abnormally.
No. | Description |
1 | Battery (+) |
2 | Parking |
3 | Ground |
4 | Signal |
Operate the motor at low speed using the stalk control.
Stop the motor operation anywhere except at the off position by disconnecting terminal 2.
Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1.
Check that the motor stops running at the off position.
Detach the rear wiper cap (A).
Remove the rear wiper arm ＆ blade (B) after removing rear wiper HEX nut (A).
Remove the rear wiper grommet (A).
Remove the tailgate trim after opening the tailgate.
(Refer to Body - "Tailgate Trim")
Disconnect the rear wiper motor connector (A) then remove the rear wiper motor (B) after loosening bolts.
Install the rear wiper motor assembly.
Tightening torque Bolt :
6.9~10.8 Nm (0.7~1.1 kgf.m, 5.1~8.0 lbf.ft)
Install the tailgate trim.
Install the rear wiper arm cap after tighting the nut.
Tightening torque Nut :
3.9~6.9 N.m (0.4~0.7 kgf.m, 2.9~5.1 lbf.ft)
Set the rear wiper blade and to the lowest defogger heat line and tailgate glass.
A : Auto stop position
