4.
Measure resistance between Pin No. 1 (Low) terminal and Pin No. 2 (High) terminal of Pressure Side Impact Sensor-Driver.
Specification : Approx. 2.5 MΩ (Actual Vehicle Test Vaule)
Fig.1) GDS Multimeter resistance check
Ignition switch "OFF"
Disconnect the battery (-) terminal cable from the battery, and wait at least one minutes.
Refer to "Shop Manual" and remove Pressure Side Impact Sensor-Driver.
Measure resistance between Pin No. 1 (Low) terminal and Pin No. 2 (High) terminal of Pressure Side Impact Sensor-Driver.
Specification : Approx. 2.5 MΩ (Actual Vehicle Test Vaule)
Fig.1) GDS Multimeter resistance check
Is the measured resistance within specifications?
 | ▶ If no problems were found with the circuits or connectors, Replace the main wiring of SRSCM and go to "Verification of Vehicle Repair" procedure. |
 | ▶ If no problems were found with the circuits or connectors, Replace the Pressure Side Impact Sensor-Driver and go to "Verification of Vehicle Repair" procedure. |
