Terminal and Connector Inspection
1.

Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

2.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

3.

Has a problem been found?

▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.

▶ Go to "Control Circuit Inspection" procedure.

Control Circuit Inspection
1.

IG "OFF"

2.

Connect VMI to GDS and perform the oscilloscope.(2 Channel):

Channel A (+) : Pin No. 1 (control) terminal (alternator connector side)

Channel A (-) : Ground

Channel A (+) : Pin No. 3 (signal) terminal (alternator connector side)

Channel A (-) : Ground

3.

IG "ON" & Engine "ON"

Specification : Refer to Fig. below

Fig.1 ) Engine Idle, No Electric Load, Alternator COM and FR terminal Waveform.

Fig.2 ) Engine Idle, Electric Load, Alternator COM and FR terminal Waveform

4.

Is the measured value within specification?

▶ Fault is intermittent caused by poor contact in the sensor’s and/or ECM’s connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure.

▶ If no problems were found with the circuits or connectors, Replace the alternator and go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика