Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check all connectors(and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.

Has a problem been found?

	▶ Repair or replace as necessary and then, Go to "Verification of Vehicle Repair" procedue.
	▶ Go to "PAS Switch Indicator Circuit Inspection" Procedure.

Ignition "ON" & Engine "OFF"

Disconnect the PAS Switch connector.

Measure the voltage between the switch Indicator circuit (Pin No.10) of the PAS and the body ground.

Fig.1) GDS Multimeter voltage check

Is the measured voltage within specifications?

	▶ Substitute with a known-good Sample of PAS Switch and check for proper operation. If problem is corrected, replace PAS Switch and then go to "Verification of Vehicle Repair" procedure.
	▶ Check the open or short of the PAS Switch Indicator circuit. And then go to "Verification of vehicle Repair" procedure.