9248958

1.

Ignition "ON".

2.

Back probe and measure voltage between Pin No.1(Signal) terminal and Pin No.3(Ground) terminal of clutch switch harness connector.

3.

Operate Clutch Switch.

Specification : On Clutch pedal not pressed : Approx. 12V / On Clutch pedal pressed : Approx. 0V

4.

Is measured value within specification?

▶ Carefully re-do this troubleshooting guide steps.

▶ If problem still occurs, replace HECU and then go to "Verification of Vechicle Repair" procedure.

caution

In case of replacing HECU, perform following procedures.

1. "ASP Calibration" for steering angle sensor offset correction.

2. "Longitudinal G-Sensor Calibration" for longitudinal sensor offset correction.

3. "Auto Detected Configuration Reset(ESP(ESC) Only)

▶ Carefully re-do this troubleshooting guide steps.

▶ If problem still occurs, replace Clutch Switch and then go to "Verification of Vechicle Repair" procedure.