3.
Has a problem been found ?
 | ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "Signal Circuit Inspection" procedure. |
Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
Thoroughly check all connectors(and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
Has a problem been found ?
| ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
| ▶ Go to "Signal Circuit Inspection" procedure. |
Ignition "OFF".
Disconnect Clutch Switch connector.
Ignition "ON".
Measure voltage between Pin No.1(Signal) terminal of clutch switch harness connector and chassis ground.
Specification : B+
Has a problem been found ?
| ▶ Go to "Ground Circuit Inspection" procedure. |
| ▶ Repair open or short in signal circuit of Clutch Switch harness connector and then go to "Verification of vehicle Repair" procedure. |
Ignition "OFF".
Disconnect Battery (-) terminal.
Disconnect Clutch Switch connector.
Measure resistance between Pin No.3(Ground) terminal of clutch switch harness connector and chassis ground.
Specification : Approx. below 1Ω
Ignition "OFF".
Connect Battery (-) terminal.
Disconnect Clutch Switch connector.
Ignition "ON".
Measure voltage between Pin No.3(Ground) terminal of clutch switch harness connector and chassis ground.
Specification : Approx. 0V
Has a problem been found ?
| ▶ Go to "Component Inspection" procedure. |
| ▶ Repair open or short in ground circuit of Clutch Switch harness connector and then go to "Verification of vehicle Repair" procedure. |
