Component Inspection
■ Check APS performance
1.

IG KEY "OFF".

2.

Connnect CH A probe to APS1 signal terminal(Pin No.3) of APS connector and CH B probe to APS2 signal terminal(Pin No.6) of APS connector.

3.

IG On / ENG Off.

4.

Measure signal waveform of APS1 and APS2 together by stepping on and off the accellerator padel.

Specification :

APS1 - MIN: 0.45V, MAX: 2.85V

APS2 - MIN: 0.20V, MAX: 11.44V

Fig.1) At Acceleration(W.O.T - Wide Open Throttle)

5.

Is the measured signal waveform O.K?

▶ Go to "Verification of Vehicle Repair" procedure.

▶ If no problems were found with the circuits or connectors, Replace the APS.

Яндекс.Метрика