Connect GDS to Data Link Connector(DLC).

IG KEY "ON" & ENG "OFF".

Perform "Actuation Test" for OCV.

Fig.1) Oil Control Valve - Intake Bank1 Actuation Test

Refer to Figure below (Also, operating sound(Clicking sound) is heard)

IG Key "OFF".

Disconnect OCV-IN connector.

Measure resistance between Pin No.1 (Power) terminal and Pin No. 2(Control) terminal of the OCV-IN. (Component Side)

Does the OCV-IN operate properly and is the measured resistence within specification? (Check variation)

	▶ Go to "System Inspection" procedure.
	▶ If no problems were found with the circuits or connectors, Replace the OCV-IN.