2.
Check that HO2S(S1) is contaminated or damaged by foreign materials.
 | ▶ Go to "Check PCV" as follows. |
 | ▶ Replace it, and go to "Verification of Vehicle Repair" procedure. |
IG "OFF" and disconnect HO2S(S1) connector.
Check that HO2S(S1) is contaminated or damaged by foreign materials.
| ▶ Go to "Check PCV" as follows. |
| ▶ Replace it, and go to "Verification of Vehicle Repair" procedure. |
Connect GDS to Data Link Connector(DLC).
IG KEY "ON" & ENG "OFF".
Perform "Actuation Test" for PCSV.
Fig.1) Canister Purge Valve Actuation Test
IG Key "OFF".
Disconnect PCSV connector.
Measure resistance between power and control terminal of the PCSV. (Component Side)
Specification : Approx. 2.0kΩ [20°C (68°F)]
Fig.2) Resistance of PCSV
Does the PCSV operate properly and is the measured resistence within specification?
| ▶ Go to "Check injector for normal operation" as follows. |
| ▶ Replace it, and go to "Verification of Vehicle Repair" procedure. |
Connect GDS to Data Link Connector(DLC).
Perform "Actuation Test" for Injector.
Fig.3) Injector Disable - Cylinder 1,2,3,4 Actuation Test
Check its RPM decrease when doing the injector's actuation test.
Is there any cylinder with no change in RPM or only a small change in RPM?
| ▶ Replace injector, and go to "Verification of Vehicle Repair" procedure. |
| ▶ Go to "Verification of Vehicle Repair" procedure. |
