3.
Measure resistance between Pin No. 2 (Signal) terminal and Pin No. 1 (Ground) terminal of evaporator sensor.
Specification : Approx. 8.7 kΩ
Fig.1) Actual Vehicle Test Data of Evaporator Sensor Resistance.
Ignition "OFF"
Refer to "Shop Manual" and remove Ambient Temperature Sensor connector.
Measure resistance between Pin No. 2 (Signal) terminal and Pin No. 1 (Ground) terminal of evaporator sensor.
Specification : Approx. 8.7 kΩ
Fig.1) Actual Vehicle Test Data of Evaporator Sensor Resistance.
Is measured value within specification?
 | ▶ Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors ( and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage. ▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Carefully re-do this troubleshooting guide steps. ▶ If problem still occurs, replace Evaporator Sensor and then go to "Verification of Vechicle Repair" procedure. |
