2.
Remove the air duct (A).
Disconnect the battery negative terminal.
Remove the air duct (A).
Disconnect the radiator reservoir hose (A).
Remove the hood lower latch.
(Refer to Body - "Hood Latch")
Remove the engine room under cover.
(Refer to Engine And Transaxle Assembly - “Engine Room Under Cover”)
Separate the ATF cooler hoses (A) from the holders on the cooling fan assembly. (A/T only)
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
Remove the headlamps.
(Refer to Body Electrical System - "Head Lamps")
Remove the radiator upper member assembly (A).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
Disconnect the cooling fan connector (A).
Remove the filler neck bolts (A).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
Remove the cooling fan (A) from the vehicle.
Tightening torque :
4.9 ~ 7.9 N.m (0.5 ~ 0.8 kgf.m, 3.6 ~ 5.8 lb-ft)
Install in the reverse order of removal.
Disconnect the wire harness connector (A) and the fan motor connector (B).
Remove the resistor (A) from the cooling fan shroud.
Tightening torque :
1.8 ~ 2.4 N.m (0.18 ~ 0.25 kgf.m, 1.3 ~ 1.8 lb-ft)
Install in the reverse order of removal.
