6.
Remove the water pump pulley (A).
Tightening torque :
9.8 ~ 11.7 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)
Remove the engine room under cover.
(Refer to Engine And Transaxle Assembly - “Engine Room Under Cover”)
Drain the engine coolant.
(Refer to Cooling System - "Coolant")
Install a jack under the edge of the oil pan to support the engine.
Remove the engine mounting support bracket.
(Refer to Engine and Transaxle assembly - "Engine Mounting")
Remove the drive belt.
(Refer to Timing system - "Drive Belt")
Remove the water pump pulley (A).
Tightening torque :
9.8 ~ 11.7 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)
Remove the water pump (A).
Tightening torque :
19.6 ~ 24.5 N.m (2.0 ~ 2.5 kgf.m, 14.5 ~ 18.1 Ib-ft)
When Installing the water pump, replaced to the new O-ring.
Install in the reverse order of removal.
Fill the radiator with coolant.
(Refer to Cooling System - "Coolant")
Start engine and check for leaks.
Remove the engine cover.
Remove the battery and the battery tray.
(Refer to Engine Electrical System - "Battery")
Remove the air cleaner assembly.
(Refer to Intake and Exhaust System - "Air Cleaner")
Remove the engine room under cover.
(Refer to Engine And Transaxle Assembly - “Engine Room Under Cover”)
Drain the coolant.
(Refer to Cooling System - "Coolant")
Remove the air control valve.
(Refer to Engine Control/Fuel System - “Air Control Valve”)
Disconnect the radiator lower hose (A).
Disconnect the heater hoses (A).
Remove the EGR cooler.
(Refer to Intake And Exhaust System - “EGR Cooler”)
Unfasten the oil feed pipe bracket bolt.
Tightening torque :
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
Disconnect the oil cooler return hose (A).
Remove the water return pipe (A).
Tightening torque :
19.6 ~ 24.5 N.m (2.0 ~ 2.5 kgf.m, 14.5 ~ 18.1 Ib-ft)
Install in the reverse order of removal.
Fill the radiator with coolant.
(Refer to Cooling System - "Coolant")
Start engine and check for leaks.
