2.
Disconnect the engine coolant temperature sensor connector (A).
Turn the ignition switch OFF.
Remove the ECTS (Refer to "Removal").
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 1 and 3.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Disconnect the engine coolant temperature sensor connector (A).
Disconnect the ignition coil connector (A) and CMPS connector (B).
Remove the harness protector (C) from the bracket.
Remove the bracket mounting bolts (A).
Remove the engine coolant temperature sensor (B).
Fill with engine coolant.
(Refer to Engine Mechanical System -"Coolant")
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
Apply the engine coolant to the O-ring.
Insert the sensor in the installation hole and be careful not to damage.
Install in the reverse order of removal.
Engine Coolant Temperature Sensor :
29.4 ~ 39.2 N.m (3.0 ~ 4.0 kgf.m, 21.7 ~ 28.9 lb-ft)
