3.
Remove the receiver with bracket.
When the receiver first arrives for replacement:
It will be in Virgin State.
It will not be configured for any specific platform.
It will not have any sensor ID's memorized.
It is important to make sure that the correct receiver is used to replace the faulty part i.e. it must be Low Line and not High Line in order to have the correct inflation warning thresholds set.
Disconnect vehicle battery.
Remove the crash pad garnish.
(Refer to BD group - "Crash Pad")
Remove the receiver with bracket.
Install in the reverse order of removal.
Re-connect battery and turn Ignition on.
After replacing the receiver, learn by using self-diagnosis device(GDS).
As manual for diagnosis methods by using diagnosis device, the main contents are as follows:
Connect self-diagnosis connector(16pins) located in the lower of driver side crash pad to self-diagnosis device, and then turn the self-diagnosis device after key is ON.
Select the "vehicle model" and "TPMS" on GDS vehicle selection screen, then select OK.
Write ID Read ID and be sure to check are the same.
After registering successfully sensor "Sensor Wireless Information" by the execution determines whether the sensor is working properly.
