2.
Install the inhibitor switch (A).
note
Lightly tighten the inhibitor switch mounting bolts so that necessary adjustments can be made.
Check that the shift lever is placed in the "N" position.
Install the inhibitor switch (A).
Lightly tighten the inhibitor switch mounting bolts so that necessary adjustments can be made.
Install the manual control lever (A).
Lightly tighten the manual control lever nut so that necessary adjustments can be made.
Align the hole (B) in the manual control lever with the "N" position hole (A) of the inhibitor switch and then insert the SST inhibitor switch guide pin (09480-A3800).
Tighten the nut (A) and bolts (B) to the specified torque.
Tightening torque
A : 17.7 ~ 24.5 N.m (1.8 ~ 2.5 kgf.m, 13.0 ~ 18.1 lb-ft)
B : 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Remove the SST (09480-A3800) from the adjusment hole.
Connect the inhibitor switch connector (A).
Install the shift cable by tightening nut (B).
Tightening torque :
9.8 ~ 13.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.8 lb-ft)
Install the air duct and the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
Connect the battery negative (-) cable.
