caution
●
In order to remove the rear glass, use the tools shown in the following figure:
[Tooling Diagram]
① Square wire
② Insert-type wire grip
[Tooling Assembly Diagram]
●
Insert and affix square wire ① into the insert hole of the wire grip ②.
In order to remove the rear glass, use the tools shown in the following figure:
[Tooling Diagram]
① Square wire
② Insert-type wire grip
[Tooling Assembly Diagram]
Insert and affix square wire ① into the insert hole of the wire grip ②.
Remove the movable glass.
(Refer to Panorama Sunroof - "Movable Glass")
Remove the roof side moulding.
(Refer to Body Side Moulding - "Roof Side Moulding")
Pull the square wire (A) to the left and right, then apply a force in the direction of the arrow to cut off the residual sealant.
Longer wires require more power, so divide Section ① and ② in half to cut off residual sealant.
Make sure that you put on gloves to protect your hands from potential injury.
Be careful about potentially burning your hands due to the heat generated from the wire in use.
Be careful when working with wiring because it may be cut.
Be careful not to damage the body.
Make sure that two or more people work together when using wires.
Remove the rear glass (A) carefully without damaging it.
