1.
Using a screwdriver or remover, remove the crash pad side cover [RH] (A).
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Using a screwdriver or remover, remove the crash pad side cover [RH] (A).
Loosen the glove box housing mounting bolts (A).
After loosening the mounting screws, then remove the glove box housing (A) by using a screw driver.
Disconnect the glove box lamp connector (A).
Remove the glove box housing mounting clip (A).
When installing glove box housing, be sure to insert lock pin (A) into wiring tape (B).
Install in the reverse order of removal.
Make sure the connector are connected in properly.
Replace any damaged clips.
