2.
Remove the center fascia panel (A) from the crash pad.
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Disconnect the negative (-) battery terminal.
Remove the center fascia panel (A) from the crash pad.
Disconnect the connecters (A) from the center fascia panel.
Remove the AVN head unit (A) after loosening the mounting screws.
Disconnect the connectors (A) from the AVN heat unit.
Connect the AVN head unit connectors.
Install the AVN head unit.
Install the center fascia panel.
Connet the negative (-) battery terminal.
Make sure the AVN Head unit connectors are plugged in properly and the antenna cable is connected properly.
Check the specified value of AVN head unit connectors in specified condition.
No. | Name | Terminal Description | Condition | Specified Condition |
A1 | - | - | - | - |
A2 | - | - | - | - |
A3 | - | - | - | - |
A4 | - | - | - | - |
A5 | SPDIF ground | SPDIF_GND | Needed connection to the AMP | Digital Audio Output |
A6 | SPDIF (+) | SPDIF+ | Needed connection to the AMP | Digital Audio Output |
A7 | ALT L | ALT from vehicle | - | - |
A8 | Illumination (+) | ILL+ from vehicle | - | - |
A9 | R position | REVERSE from vehicle | - | - |
A10 | - | - | - | - |
A11 | - | - | - | - |
A12 | - | - | - | - |
A13 | - | - | - | - |
A14 | Ignition 1 | IGN1 from vehicle | - | - |
A15 | SPDIF (-) | SPDIF- | Needed connection to the car | Digital Audio Output |
A16 | Door unlock | DOOR UNLOCK from vehicle | - | - |
A17 | Illumination (-) | ILL- from vehicle | - | - |
A18 | Remote antenna | Remote supply for motorised antenna | Acc on | 9V ~ 18V |
No. | Name | Terminal Description | Condition | Specified Condition |
B1 | MM CAN high | MM_CAN_HIGH | Needed connection to the car | Communication with external amp |
B2 | - | - | - | - |
B3 | Parking | PARKING from vehicle | - | - |
B4 | Steering remocon | Steering Wheel Remote Control | Steering Wheel switch pushed | 0.5V ~ 3V |
B5 | - | - | - | - |
B6 | - | - | - | - |
B7 | AUX video | AUX Video | Needed connection to the MultiJack | - |
B8 | AUX right input | AUX Right Sound Signal | External Auxiliary device is Audio playing (At time of Aux jack use) | A waveform synchronized with sound is output |
B9 | AUX ground | AUX Reference Ground | Needed connection to the MultiJack | Below 1 ohm |
B10 | MIC (+) | Bluetooth MIC+ | Input the Voice Signal via MIC | A waveform synchronized with Voice data via MIC |
B11 | Battery (+) | Battery | Always | 11 ~ 14 V |
B12 | Battery (+) | Battery | Always | 11 ~ 14 V |
B13 | MM CAN low | MM_CAN_LOW | Needed connection to the car | Communication with external amp |
B14 | Auto light | AUTO-LIGHT from vehicle | - | - |
B15 | P position | P-POSITON from vehicle | - | - |
B16 | Speed | Speed Sensor Signal | Engine switch on(IGN), car is moved slowly | Approx. 5V Level Pulse Generation |
B17 | Remocon ground | Steering Wheel Remote Control GND | Always | Below 1 ohm |
B18 | ACC | Accessory | Engine switch on(ACC) | 11 ~ 14 V |
B19 | AUX video ground | AUX Video GND | Always | Below 1 ohm |
B20 | AUX DETECT | AUX Signal Input Detect | Auxiliary device is inserted | 0V(Low) → 5V(High) |
B21 | AUX left input | AUX Left Sound Signal | External Auxiliary device is Audio playing (At time of Aux jack use) | A waveform synchronized with sound is output |
B22 | MIC (-) | Bluetooth MIC- | Input the Voice Signal via MIC | A waveform synchronized with Voice data via MIC |
B23 | Ground | Ground | Always | Below 1 ohm |
B24 | Ground | Ground | Always | Below 1 ohm |
No. | Name | Terminal Description | Condition | Specified Condition |
C1 | C CAN (-) | CHASSIS_CAN_LOW | Needed connection to the car | - |
C2 | C CAN (+) | CHASSIS_CAN_HIGH | Needed connection to the car | - |
C3 | - | - | - | - |
C4 | - | - | - | - |
C5 | - | - | - | - |
C6 | - | - | - | - |
C7 | - | - | - | - |
C8 | - | - | - | - |
C9 | - | - | - | - |
C10 | - | - | - | - |
C11 | B CAN (+) | BODY_CAN_HIGH | Needed connection to the car | - |
C12 | B CAN (-) | BODY_CAN_LOW | Needed connection to the car | - |
C13 | - | - | - | - |
C14 | Airbag | AIRBAG from vehicle | - | - |
C15 | - | - | - | - |
C16 | Navigation voice (-) | NAVI_VOICE- | Needed connection to the AMP | Analog Audio Output |
C17 | Navigation voice (+) | NAVI_VOICE+ | Needed connection to the AMP | Analog Audio Output |
C18 | Door open | DOOR OPEN from vehicle | - | - |
C19 | - | - | - | - |
C20 | - | - | - | - |
C21 | Ground | Ground | Always | Below 1 ohm |
C22 | Video ground | CARMERA Video Ground | Needed connection to the CARMERA | Below 1 ohm |
C23 | Camera video input | CARMERA Video | Needed connection to the CARMERA | NA |
C24 | Camera battery (+) | CARMERA Video POWER | Needed connection to the CARMERA | 5V~5.5V |
No. | Name | Terminal Description | Condition | Specified Condition |
1 | USB VCC | USB / iPod power | USB/iPod device is inserted | 4.9V ~ 5.1V |
2 | USB D (-) | USB D- | USB device is inserted | 3.2V ~ 3.45 |
3 | USB D (+) | USB D+ | USB device is inserted | 3.2V ~ 3.45 |
4 | USB ground | USB / iPod Ground | USB/iPod device is inserted | Below 1 ohm |
