4.
Remove the panorama sunroof glass motor (A) after loosening the screws and disconnecting the connector.
Close the panorama sunroof glass and blind completely (Full close position).
Disconnect the negative (-) battery terminal.
Remove the roof trim assembly.
(Refer to Body - "Roof Trim")
Remove the panorama sunroof glass motor (A) after loosening the screws and disconnecting the connector.
Check the wiring connector of the panorama sunroof glass motor as below table.
Terminal | Test condition | Test : Desired result |
3 - GND | IG2 ON | Check for voltage to ground : There should be battery voltage |
1 - GND | Under all conditions | Check for continuity to ground : There should be continuity. |
6 - GND | Under all conditions | Check for voltage to ground : There should be battery voltage. |
Remove the blind motor (A) after loosening the screws and disconnecting the connector.
Check the wiring connector of the blind motor as below table.
Terminal | Test condition | Test : Desired result |
1 - GND | Under all conditions | Check for continuity to ground : There should be continuity. |
6 - GND | Under all conditions | Check for voltage to ground : There should be battery voltage. |
Connect the panorama sunroof glass and blind motor and each connectors.
Be careful not to reinstall the motors on the panorama sunroof.
Connect the negative (-) battery terminal.
Start the vehicle engine.
Check the motor's operation by pressing the panorama sunroof switch.
Terminal | Operation Test |
Glass open switch | Both the glass and blind motors operate |
Glass close switch | Both the glass motors operate |
Glass tilt up switch | Both the glass and blind motors operate |
Blind open switch | The blind motor operates |
Blind close switch | The blind motor operates |
Pless the auto close switch after checking the motor's operation.
Install the panorama sunroof glass motor and blind motor. And then perform the resetting procedure of the panorama sunroof.
Use only the auto close switch.
