5928203

1.

Ignition "OFF"

2.

Disconnect Driver air mix actuator and connect A/C control unit main harness connector.

3.

Connect (+) terminal of battery to WARM(+) of Driver air mix actuator and (-) terminal to COOL(-).(Component side)

4.

Verify that the temperature actuator operates to the WARM position.

5.

Verify that the temperature actuator operates to the COOL position with reverse connecting.(COOL(+) and WARM(-) ) .(Component side)

Specification : Refer the specifications in fig.1)

note

To view Flash content, you need to install the appropriate browser extension

Fig.1)

Actuator harness	WARM(+)	COOL(-)	Door position
Battery terminal	12 V	ground	Max.warm
Battery terminal	ground	12 V	Max.cool

Fig.1) ※ Function of the actuator motor according to terminal connection type. (observe safety regulations)

6.

Is "Door position" display near the specified value?

	▶ Go to "Check potentiometer" procedure.
	▶ Substitute with a known-good Driver air mix actuator and check for proper operation. If the problem is corrected, replace Driver air mix actuator and then go to "Verification of Vehicle Repair" procedure.

7.

Ignition "OFF"

8.

Connect Driver air mix actuator and A/C control unit main harness connector.

9.

Ignition "ON"

10.

Measure voltage between Signal(F/B) terminal of Driver air mix actuator harness connector and Sensor ground(-) terminal of A/C-ECU harness connector .(Component side)

Specification : Refer the specifications in fig.2)

note

To view Flash content, you need to install the appropriate browser extension

Fig.2)

Door position	Voltage
Max. cool	0.45 V
Max. warm	4.55 V

Fig.2) ※ Voltage value of Air Mix potentiometer as a function of temp door position.

11.

Is "voltage" display near the specified value?

	▶ Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
	▶ Substitute with a known-good Driver air mix actuator and check for proper operation. If the problem is corrected, replace Driver air mix actuator and then go to "Verification of Vehicle Repair" procedure.