2.
Using a screwdriver or remover, remove the rear pillar trim (A).
When installing the belt, make sure not to damaged the pretensioner.
Remove the following items first :
Rear seat assembly
(Refer to the BD group - "Rear Seat")
Using a screwdriver or remover, remove the rear pillar trim (A).
After loosening the mounting screws and clips, then remove the partition side trim (A).
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
After loosening the mounting bolts, then remove the rear seat mounting bracket (A).
After loosening the mounting screw, then remove the rear wheel housing trim (A).
Disconnect the high mounted stop lamp connector (A).
Remove the rear seat belt cover (A).
Using a screwdriver or remover, remove the rear package tray trim (A).
After loosening the retractor (B) mounting bolt, then remove the rear seat belt (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Installation is the reverse of removal.
Make sure the connectors are connected in properly.
Replace any damaged clips.
When installing the belt, make sure not to damaged the retractor.
Rear seat assembly.
(Refer to the BD group - "Rear Seat")
After loosening the mounting screws, then remove the rear door scuff trim (A).
Using a screwdriver or remover, remove the rear transverse trim (A).
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)
After loosening the mounting blots, then remove the rear seat bracket (A).
Using a screwdriver or remover, remove the luggage lamp (A).
Disconnect the lamp connector (B).
After loosening the mounting screws, then remove the luggage side trim (A).
Remove the rear seat belt upper anchor cover (A).
After loosening the mounting screws, then remove the rear pillar trim (A).
After loosening the retractor (B) mounting bolts, then remove the rear seat belt (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)
Installation is the reverse of removal.
Make sure the connectors are connected in properly.
Replace any damaged clips.
Remove the following items first :
Rear seat cushion assembly.
(Refer to the BD group - "Rear Seat")
After loosening the mounting bolt, then remove the rear seat belt buckle (A).
[LH]
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)
[RH]
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)
Installation is the reverse of removal.
