Remove the front door trim.

(Refer to the Body group - Front door)

Remove the front door latch.

(Refer to the Body group - Front door).

Disconnect the connectors from the actuator.

Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Remove the rear door trim.

(Refer to the Body group - Rear door)

Remove the rear door latch.

(Refer to the Body group - Rear door)

Disconnect the connectors from the actuator.

Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Remove the trunk lid trim panel.

(Refer to the BD group - "Trunk lid")

Disconnect the 3P connector from the actuator.

Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Remove the front door trim.

(Refer to the Body group - Front door)

Remove the front door latch.

(Refer to the Body group - Front door).

Disconnect the connectors from the actuator.

Check for continuity between the terminals in each switch position when inserting the key into the door according to the table.

Remove the rear door trim.

(Refer to the Body group - Rear door)

Remove the rear door latch.

(Refer to the Body group - Rear door)

Disconnect the connectors from the actuator.

Check for continuity between the terminals in each switch position according to the table.

Disconnect the negative battery terminal.

Remove the rear trunk lid trim, and then remove the trunk lid switch from the actuator.

Check for continuity between the terminals in each switch position according to the table.

Remove the steering column upper and lower shrouds after removing 3 screws.

Disconnect the 6P connector (A) from the key warning switch.

Check for continuity between the terminals in each position according to the table.