1.
Remove the circlip (B) from the driveshaft spline (A).
Do not disassemble the BJ assembly.
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
The boot band should be replaced with a new one.
Remove the circlip (B) from the driveshaft spline (A).
Remove both boot bands from the transaxle side joint(TJ) case.
Pull out the boot from transaxle side joint case (B).
While dividing joint(TJ) boot (A) of the transaxle side, wipe the grease in TJ case (B) and collect them respectively.
Make alignment marks on spider roller assembly (A), joint case (B), and shaft spline (C) to aid reassembly.
Remove the snap ring (A) and spider roller assembly (B) from the shaft.
Remove the spider assembly (B) from the driveshaft (A) using the special tool (09495-33000).
Clean the spider assembly.
Remove the boot (A) of the transaxle side joint(TJ).
For reusing the boot (A), wrap tape (B) around the driveshaft splines (C) to protect the boot (A).
Dynamic damper is impossible to removal. Because it is press in the shaft.
