2.
Remove the heater duct (A).
Remove the floor Interior console assembly.
(Refer to "Interior (Console)" in BD group)
Remove the heater duct (A).
Remove the select cable assembly after removing select cable snap pin (A) and clip (B).
Remove the shift lever assembly (B) after removing shift lever assembly installation bolts (A-4ea).
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
Remove the clip (A) from the shift cable assembly.
Set securely.
Installation is the reverse of removal.
Disconnect the select and shift cable assembly (B) after removing the pin (A).
Installation is the shift cable (A).
Selected cable should be separated from the shift lever pin.
Installation is the shift lever assembly (A).
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
Shift to the 3th gear position.
Insert the selected cable (A) to the shift lever assembly pin (B).
You have to push in the adjust (C).
Remove the neutral position pin (D).
Install the snap pin (E).
Remove the floor Interior console assembly.
(Refer to "Interior (Console)" in BD group)
Remove the heater duct (A).
Remove the select cable assembly after removing select cable snap pin(A) and clip (B).
Remove the shift lever assembly (B) after removing shift lever assembly installation bolts (A-4ea).
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
Remove the clip (A) from the shift cable assembly.
Set securely.
Remove the retainer (A) and nuts (B-2ea).
Tightening torque:
11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)
Remove the pins (A).
Remove the cable (B) from the cable bracket at manual transaxle assembly side.
Remove the shift cable and select cable at cabin room.
Check the select cable for proper operation and for damage.
Check the shift cable for proper operation and for damage.
Check the boots for damage.
Check the boots for wear abrasion sticking, restricted movement or damage.
Check for the weak or damaged spring.
Installation is the reverse of removal.
Disconnect the select and shift cable assembly (B) after removing the pin (A).
Installation is the shift cable (A).
Selected cable should be separated from the shift lever pin.
Installation is the shift lever assembly (A).
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
Shift to the 3th gear position.
Insert the selected cable (A) to the shift lever assembly pin (B).
You have to push in the adjust (C).
Remove the neutral position pin (D).
Install the snap pin (E).
