1.
Disconnect the push rod from the master cylinder by removing the snap pin (A) and washer.
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
Disconnect the push rod from the master cylinder by removing the snap pin (A) and washer.
Remove the clutch pedal mounting nuts (A-2ea, B-3ea).
Tightening torque:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
Remove the battery and ECM.
(Refer to "Manual transaxle system" in MT group.)
Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.
Remove the clutch master cylinder by turning it clockwise (A).
