Component Location
General Description

Information related immobilizer,that are classified as 2(two) parts independently, is memorized in EEPROM. PCM/ECM check these 2(two) information berfore proceeding immobilizer authentication. With synchronized both information, PCM/ECM starts immobilizer authentication procedure. If both information is not synchronized, PCM/ECM stops immobilizer authentication, Limphome function will not be activated, and memorizes DTC P1695.If DTC P1695 is retrieved again, after performing new key teaching procedure, PCM/ECM should be replaced with new one.

DTC Description

If key/password information in PCM/ECM is not matching or there is write error on EEPROM as hardware, DTC P1695 is set.

DTC Detecting Condition

Item

Detecting Condition

Possible Cause

Enable Conditions

•

IG ON

1.

Faulty ECM

Threshold value

•

ECM internal memory error(EEPROM or Flash etc.)

•

Write error on ECM internal memory (EEPROM or Flash etc.)

Diagnostic Circuit Diagram
note
To view Flash content, you need to install the appropriate browser extension
note
To view Flash content, you need to install the appropriate browser extension
Signal Waveform & Data

Fig.1) It shows that ECU is learnt status.

Яндекс.Метрика