1.
Remove the glass (A) by lifting it up.
caution
●
Do not damage the roof panel.
Put on glove to protect your hands.
Remove the glass (A) by lifting it up.
Do not damage the roof panel.
Installation is the reverse of removal.
Remove the roof trim.
(Refer to the BD group - "Roof Trim")
Confirm the position of guide whether it is closed or not when you remove the motor.
Disconnect the motor connector (B), remove the screws and then remove the motor (A).
Installation is the reverse of removal.
Make sure to initialize the motor.
Open the glass fully.
Remove the mounting pins (C), from the frame (B) and then remove the deflector (A).
Installation is the reverse of removal.
Remove the follows parts.
Interior trim
(Refer to the BD group - "Interior Trim")
Roof trim
(Refer to the BD group - "Roof Trim")
Sunroof glass.
After loosening the mounting bolts, then remove the side airbag mounting bracket (A).
After loosening the mounting bolts, then remove the assist handle bracket (A).
After loosening the mounting bolts, then remove the center sunroof mounting bracket (A).
After loosening the mounting bolts, then remove the rear sunroof mounting bracket (A).
Disconnect the drain tubes (A).
After loosening the mounding bolts and nuts, remove the sunroof assembly (A).
Take care not to scratch the interior trims and other parts.
Tightening torque:
(B) : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
(C) : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
Installation is the reverse of removal.
Make sure to initialize the motor.
Remove the sunroof assembly.
After loosening the mounting screw, then remove the sunshade stopper (B).
Remove the sunshade assembly (A).
Installation is the reverse of removal.
Remove the sunroof assembly.
Remove a mechanism assembly (A) after lowering a guide thoroughly by pushing a slider (B) to rear.
Remove the shoe (A) and slider (B).
Installation is the reverse of removal.
Make sure to align the slide with the center of “(A)” and “(B)”
Make sure to initialize the motor.
Check that the glass has been installed.
Finished height adjustment.
Push the close switch. (Keep on pushing the switch)
Press and hold the CLOSE button for more than 10 seconds until the sunroof moves up to the tilt position.
Release the sunroof CLOSE button with in 3 seconds. And then press and hold the CLOSE button once again within 3 seconds until the sunroof do as follows;
Tilt up → Slide Open → Slide Close
Then release the lever.
When the sunroof is closed completely, turn OFF the UP switch initialize the motor completely.
After initial vehicle assembly.
If the initial value is erased or damaged because of short power electric discharge during operation.
After using the manual handle.
Use the sunroof emergency handle to close or open the sunroof manually if the sunroof cannot be closed electronically due to motor or controller electrical malfunction.
Operating method.
Remove the roof trim.
Push the emergency handle up into the hexagonal drive (A) of the sunroof motor. You must push hard enough to disengage the motor clutch; otherwise the emergency handle will slip due to incomplete fit in the motor.
Carefully turn the emergency handle clockwise to close the sunroof.
After closing the sunroof, wiggle the handle back and forth as you remove the tool from the motor, to ensure the motor clutch reengages.
A 5mm hex socket may be used in place of the emergency handle, with a” Speeder” type handle.
Do not use power tools to operate the sunroof.
Damage to the components may occur.
