Check the steering remote control switch (A) for resistance between terminals in each switch position.
Switch | Connector terminal | Resistance(± 5%) |
Seek up | 3-4(RH) | 430 Ω |
Seek down | 3-4(RH) | 1.11 kΩ |
Mode | 3-5(LH) | 2.11 kΩ |
Volume up | 3-5(LH) | 4.61 kΩ |
Volume down | 3-5(LH) | 6.81 kΩ |
Voice | 3-5(LH) | 10.71 kΩ |
END | 3-6(RH) | 18.91 kΩ |
SEND | 3-6(RH) | 40.91 kΩ |
Disconnect the negative (-) battery terminal.
Remove the driver airbag module.
(Refer to the RT group - "DAB and Clock spring")
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
Remove the steering wheel cover (A) after loosening 6 screws.
Remove the remote control switch after loosening 1 screw and disconnecting the connector.
[RH]
[LH]
Reassemble the steering wheel remote control switch after connecting the connector.
Reassemble the steering wheel.
Reassemble the driver airbag module.
Make sure the audio remote control switch and the airbag module connectors are plugged in properly.
