3.
Remove the installation bolt (B), and then remove the crankshaft position sensor.
Check signal waveform of CKPS and CMPS using a GDS.
Specification: Refer to “Waveform”
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Disconnect the crankshaft position sensor connector (A).
Remove the installation bolt (B), and then remove the crankshaft position sensor.
Installation is reverse of removal.
Crankshaft position sensor installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
