1.
Remove the tie rod end (B) from the tie rod (A).
Tightening torque :
49.0 ~ 53.9 N.m (5.0 ~ 5.5 kgf.m, 36.1 ~ 39.8 lb-ft)
Remove the tie rod end (B) from the tie rod (A).
Tightening torque :
49.0 ~ 53.9 N.m (5.0 ~ 5.5 kgf.m, 36.1 ~ 39.8 lb-ft)
Remove the bellows band (A).
Remove the bellows clip (A).
Pull the bellows out toward the tie rod.
Check for rust on the rack when the bellows are replaced.
Remove the feed tube(A) from the rack housing.
While moving the rack slowly, drain the fluid from the rack housing. [Boh side]
Remove the tab washer (A) which fixes the tie rod (B) and rack (C).
While moving the rack slowly, drain the fluid from the rack housing. [Boh side]
Remove the tie rod (B) from the rack (A), taking care not to twist the rack.
Remove the rack bushing (A) the from rack (B).
Remove the yoke plug (B) with a 14mm socket (A).
Remove yoke plug (A), rack support spring (B), rack support yoke (C) and bushing (D).
Remove the reck bar from the reck housing.
Loosen the pinion plug (A) and pinion lock nut (B).
Tightening torque
Pinion plug : 21.0 ~ 35.0 N.m (2.1 ~ 3.5 kgf.m, 15.2 ~ 25.3 lb-ft)
Pinion lock nut : 40.0 ~ 50.0 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)
Disassembly the Pinion Valve Assembly.
Reassembly is the reverse of the disassembly.
