1.
Remove the glass (A) by lifting it up.
caution
●
Do not damage the roof panel.
Put on glove to protect your hands.
Remove the glass (A) by lifting it up.
Do not damage the roof panel.
Installation is the reverse of removal.
Remove the roof trim.
(Refer to the BD group - "Roof Trim")
Confirm the position of guide whether it is closed or not when you remove the motor.
Disconnect the motor connector (B), remove the screws and then remove the motor (A).
Installation is the reverse of removal.
Make sure to initialize the motor.
Open the glass fully.
Remove the mounting pins (C), from the frame (B) and then remove the deflector (A).
Installation is the reverse of removal.
Remove the follows parts.
Interior trim
(Refer to the BD group - "Interior Trim")
Roof trim
(Refer to the BD group - "Roof Trim")
Sunroof glass.
After loosening the mounting bolts, then remove the side airbag mounting bracket (A).
After loosening the mounting bolts, then remove the assist handle bracket (A).
After loosening the mounting bolts, then remove the center sunroof mounting bracket (A).
After loosening the mounting bolts, then remove the rear sunroof mounting bracket (A).
Disconnect the drain tubes (A).
After loosening the mounding bolts and nuts, remove the sunroof assembly (A).
Take care not to scratch the interior trims and other parts.
Tightening torque:
(B) : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
(C) : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
Installation is the reverse of removal.
Make sure to initialize the motor.
Remove the sunroof assembly.
After loosening the mounting screw, then remove the sunshade stopper (B).
Remove the sunshade assembly (A).
Installation is the reverse of removal.
Remove the sunroof assembly.
Remove a mechanism assembly (A) after lowering a guide thoroughly by pushing a slider (B) to rear.
Remove the shoe (A) and slider (B).
Installation is the reverse of removal.
Make sure to align the slide with the center of “(A)” and “(B)”
Make sure to initialize the motor.
