7378315

Check immobilizer lamp circuit.

(1)

Ignition "ON" & Engine "OFF"

(2)

Check if immobilizer lamp operates properly.

note

Right after ignition "ON", Immobilizer lamp lights up for 30sec. If lamp blinks 5 times after ignition "ON", a fault exists in immobilizer system.

(3)

Is the immobilizer lamp operating properly?

	▶ Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
	▶ Go to "Component Inspection" procedure

IG KEY ON & Engine "OFF"

Specification : Immobilizer lamp "ON"

note

To view Flash content, you need to install the appropriate browser extension

note

To view Flash content, you need to install the appropriate browser extension

Is the Immobilizer lamp "ON"?

	▶ Substitute with a known-good PCM/ECM and check for proper operation. If the problem is corrected, replace PCM/ECM and then go to "Verification of Vehicle Repair" procedure. note ECM substitued for old one must be in "Virgin" or "Neutral" status and Pin code is requied to Neutralize ECM and to Register transponder key
	▶ Check that fuse has blown off and harness between PCM/ECM connector and Battery is in normal condition. And. check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.