Connect the GDS on the Diagnosis Link Connector (DLC).
Start engine and check output voltages of APS 1 and 2 at C.T and W.O.T.
(Check pin number : APS 1 = 4 and 3 / APS 2 = 5 and 6)
Specification: Refer to Specification Section.
Turn ignition switch OFF and disconnect the GDS from the DLC.
Disconnect APS connector and measure resistance between APS terminals 2 and 3 (APS 1).
Specification: Refer to Specification Section.
Disconnect APS connector and measure resistance between APS terminals 1 and 5 (APS 2).
Specification: Refer to Specification Section.
